Sensing element: NTC
Set-point range: (could set upper/lower limit)
Inside sensor:5-35
℃
[41-95
℉
]
Outside sensor:5-45
℃
[41-113
℉
]
Only outside sensor:0-90
℃
[32-194
℉
]
Operating temperature: 0-45
℃
[32-113
℉
]
Operating humidity: 5-95%RH ( non-condensing )
Button: Silicone Rubber Keypad
Power supply: AC85-250V
，
50/60Hz
Power consumption: <3W
Wirings: Wiring 0.0016x0.0062sq. in.( 1×4 mm
2
wires)
Switch current rating: 16 A(Resistive)
Housing: PC
＋
ABS Flame Retardant
Dimensions:2.95x4.82x1.04”
(75×122.5×26.5mm) (W×H×D)
Hole pitch: 3.29” (83.5 mm)(standard)
Protection class:IP30
OPERATION
On/Off: Press “POWER” to turn on, press “POWER” again to turn off, and off the electric heating equipment at the same time.
Setting temperature: When power is on, press “Down” to reduce set-point, press “Up” to raise set-point. (0.5
℃
[1
℉
] changed each press.)
Electric heating equipment’s control: When the room temperature is 1
℃
(when the offset is 2
℉
) lower than the setting temperature, the thermostat will put through the power of the
electric heating equipment, and the LCD will display “ ”; When the room temperature is 1
℃
(when the offset is 2
℉
) higher than the setting temperature, the thermostat will close the power of
the electric heating equipment, and “ ” will disappear.
If open the ”output delay” function, (refer to No.15 and No.16 of the parameter list): “ ” flashing means delaying, and the thermostat will output. When the delay time shows, the LCD
shows “ ”, the thermostat output, and put through the power of the electric heating equipment.
MANUAL MODE
、
TIMER ON/OFF FUNCTION MODE AND 4 PERIODS MODE CHOICES
Timer on: Press “Mode” for 3 seconds, LCD shows “XX”, press “Up” or “Down” to adjust the parameter.
“01” stands for manual mode, that means after set the temperature, and no change, LCD shows “
”.
“02” stands for timer on/off mode, LCD shows “
”.
“03” stands for 4 periods mode, LCD shows corresponding time symbol.
4 PERIODS’ CORRESPONDING SYMBOLS:
Period 1
Period 2
Period 3
Period 4
Wake
Leave
Return
Sleep
TIMER AND TIMER ON/OFF FUNCTION SETTING
Time adjust: press “Time”, till to display “hh:mm” and “hh” flashes
，
press “Up” or “Down” to adjust hour; press “Time”, “mm” flashes, press “Up” or “Down” to adjust minute; press “Time”,
then week flashes, press “Up” or “Down” to adjust week.
Timer on: Press “Time”, till to display “TIMER ON” and “hh” flashes
，
press “Up” or “Down” to adjust time on hour, press “Time”, “mm” flashes, press “Up” or “Down” to adjust the time
on minute; Press “Time”, till “TIMER OFF” and “hh” flashes. Use the above method, setting the time on/off hour and minute, the time on/off will be valid until to be canceled.
Canceling timer on: Method 1: Setting the time on/off hour and minute as “00”; Method 2: As per the tip of the “manual mode, timer on/off function mode and 4 periods mode choices”,
