Opening the ProGuard800 control panel
1.
Remove the ProGuard800 from its packing.
2.
Push the little pins at the bottom side of the central unit
gently with a screwdriver as shown on the picture and
move the screwdriver up.
3.
Remove the front of the central unit. You will see that
the front is connected to the backside with two
fasteners and the flat-cable of the keyboard.
Removing the back-up battery
1.
Remove the back-up battery by pushing the bottom
side of the clip.
2.
Retain the battery and the clip well. They will be placed
in the panel later.
Disconnecting the internal siren
Disconnect the internal sire. This is a bit more comfortable when
you accidentally activate the siren during the installation. This is
the upper white plug on the PCB mounted at the front panel of
the ProGuard800.
Connecting the telephone cord
1.
Get the enclosed telephone cord from the box and
guide it through the hole on the back side of the central
unit. Connect the telephone cord to the left telephone
connector.
2.
Disconnect the cord of your main telephone
connection. Connect the other end of the enclosed
telephone cord to the now available main telephone
connection.
3.
Guide the disconnected cord of your main telephone connection through the hole
on the back of the central unit and connect this to the right connector.
Mounting the panel to the wall
1.
The panel has four mounting holes.
2.
Position the panel on the wall and mark the holes with
the marker.
3.
Make sure you do not mark the holes in places where
there could be wiring in the wall.
4.
Drill the holes in the wall and place the enclosed
plugs.
5.
Place the two screws in the upper holes and let them
stick out 5 mm.
6.
Hang the panel at these upper screws.
7.
Now place the lower two screws, do not tighten them too much.
-3-
©
HAIBRAIN
Summary of Contents for ProGuard800 Series
Page 16: ...ZI0488B 1 09...
