5.
Press
9
(the display now shows
6.VM EVENT OPT. 1.BURGLARY
).
6.
With
the
/
keys you can step through all events and with
9
confirm your choice.
( 6 is activating, 7 is deactivating) You could also enter the number of your choice
directly, followed by
9
. The display now shows for instance:
6.ARM ENABLED
.
With the
key you can change this into
DISARMED
and confirm with
9
. This way
you can enter your preferences for every spoken announcement.
Entrance codes
The ProGuard800 has several entrance codes for the various ways of use. You already know
two codes. Code 1111 for programming your ProGuard800 and code 1234 as Master code for
the user. Change these codes into your own codes after getting acquainted with the system.
Adding a user code
To add a code for your housemates who should be able to shut off the alarm system, you act
as follows:
1.
Log in to the programming menu by pressing
9
, followed by 1234 (the display now
shows:
MAIN MENU 1.STOP COMM.
).
2.
Press 4 (the display now shows:
4.USER CODES
).
3.
Press 20 (the display now shows:
4.USER CODES USER 20 NON_CTRL
).
4.
Press
9
(the display now shows:
USER 20 NON_CTRL 1.EDIT CODE
).
5.
Press
9
(the display now shows:
1.EDIT CODE 0000
).
6.
The cursor is located at the first number. Change the code into a code not used
before.
7.
Push
9
to save the new code.
8.
You can leave the programming menu by pushing
8
3 times.
1
If you enter a code which matches an already existing code, the central unit will give
an error message by means of a tone. The new code will not be saved. 0000 is not a
valid user code. You can use this for removing a user code.
Code 1-29 can only be changed with the Master code. The installer’s code, guard
code and emergency room code can only be changed by the installer.
ProGuard800 display and status Indicators
System status indicators
The system status indicators inform you about the status of the system
like alarm ON, alarm OFF and electricity failure.
If the Armed LED
is…
±
It means…
Off
The system is disarmed.
On
The system is armed.
Flashing
An alarm has occurred. Alarm indication is cleared the next time that an
arming sequence is initiated or after the relevant event has been viewed in
the event log.
Table 3.1: Alarm status indicators
-11-
©
HAIBRAIN
Summary of Contents for ProGuard800 Series
Page 16: ...ZI0488B 1 09...
