AUTO:Auto operation mode
The 2
nd
column
CHECK:Auto diagnostic,trouble shooting
1: display the current failure code at temp. area, and 1 in fan speed area will be light.
2: display the last failure code, at temp. area, and 2 in fan speed area will be light.
：
Low fan speed
:Medium fan speed
:High fan speed
AUTO:Auto fan running
FIX: Fix fan speed,it will display only when fixed fan speed is requested to main indoor unit.
CENTRAL:Central control mode
The 3
rd
column
STANDBY:Waiting mode
FILTER:Request of filter to be cleaned
Preheat:Preheating mode
DEFROST:Dfrosting mode
LOUVER/MANUAL:Swing mode
2. Operation
2.1 Press ON/OFF button on wired controller.
Wired controller will display the state of last time (timer, swing etc will not display). And air
conditioner will run, LED of wired controller will be light.
2.2 Select running mode
Press “mode”, the mode will change as follow:
[AUTO]
→
[FAN]
→
[COOL]
→
[DRY]
→
[HEAT]
→
[AUTO]
2.3 TEMP button
Press TEMP +/- to set indoor temperature.
The preliminary set temperature at any mode is 24 , but in FAN mode, no set temperature.
℃
2.4 FAN button
Press “FAN” button to select fan speed, fan mode will change as follow(in DRY mode, fan speed is
AUTO):
[AUTO]
→
[HIGH]
→
[MED]
→
[LOW]
→
[AUTO]
In FAN mode, there is no AUTO FAN speed.
If the main indoor unit needs to fix the fan speed, the fan speed can not be changed, and LCD will
display FIX.
2.5 SWING button
Press SWING button, the flap will swing accordingly.
2.6 ON/OFF button
Press ON/OFF again, shut off the unit. LED of wired controller will be off.
3. Installation
3.1 Take off the top cover of wired controller, PCB is set at the top cover. Be careful not to damage
PCB.
*
.Dip switch setting
item
switch
state
function
ON
Set as slave wired controller
Changeover
between
master/slave wired
controller
SW1
OFF
Set as master wired controller
ON
Display Fahrenheit
Changeover
between Celsius and
Fahrenheit
SW2
OFF
Display Celsius
3.2 Requirement for wire between indoor and wired controller and communication wire
Connect the terminals (A, B, C) at the bottom of wired controller with the terminals (A, B, C) on
indoor PCB respectively.
Все каталоги и инструкции здесь:
http
:
//splitoff.ru/tehn-doc.html
