.6.
Turning on the Appliance
Starting a wash cycle
- Make sure that the plug for the appliance is inserted into the wall
socket.
- Make sure that the water supply is turned on to full pressure.
- Load the dishwasher (see the section entitled,"Loading the
Dishwasher").
- Pour in the detergent (see the section entitled,"Salt,Dergent and
Rinse Aid").
- Turn the knob located on the right of the control panel in the
clockwise direction until the number or symbol for the cycle set-
ting is aligned with the reference mark(see the section entitled,
"Wash Cycle Table").
- Press the ON-OFF button,and the ON-OFF light will turn on.At
this point,the wash cycle will begin.
Cancelling or modifying a wash cycle setting
Premise:A cycle that is underway can only be modified if it has
only been running for a short time.Otherwise, the detergent may
have already been used,and the appliance may have already
drained the wash water If this is the case,the detergent dispenser
must be refilled(see the paragraph entitled,"Loading the
Detergent").
Press the ON-OFF button,and the ON light will turn off.Rotate
the knob in the clockwise direction to the desired cycle setting
(see the section entitled.:Starting a wash cycle...").Then, turn
the dishwasher back on using the ON-OFF button.
If you forget to load some of the dishes
The wash cycle can be interrupted by pressing the ON-OFF button.
You can then load additional dishes and turn the appliance back
on.The cycle will start where it left off.
Wait a few minutes before unloading the dishwasher to avoid
handling the dishes and utensils while they are still hot and more
susceptible to breakage.They will also dry better.
Wash Cycle adjustment Buttons
Button
This button(see "close-up View - Control Panel",letter"G")is used
for the normally dirty dishes,pots and pans.It is standard daily
cycle.
1/2 load Button
This button(see "close-up View - Control Panel",letter"H") make
it possible to wash dishes using only the upper rack if there are
not enough dishes for a full load.This will allow you to save on
water and eletrical energy.
Rapid
This button(see "close-up View - Control Panel",letter "I") ,when
pressed with wash cycle 4(glassware) make it possible to run the
wash cycle at a lower temperature (50
) and eliminates the dry-
ing phase.
It can be used before setting any of the wash cycles, except for
the intensive cycles (if included in the wash cycle table ). Please
keep in mind that the amount of degertent should also be cut in
half.
At the end of the wash cycle
When the knob stops turning and is aligned with a STOP mark
(see figure),the cycle has finished.Turn off the appliance using
the ON-OFF button,turn off the water supply and open the door
of the dishwasher.
GB
