Installationan and Accessory Parts
appliance is level,it will help ensure proper performance.
7.3 Cold Water Connection
Connect the cold water supply hose to a threaded 3/4(gas) connector and make sure that it
is fastened tightly in place (see Fig 1).
If the water pipes are new or have not been used for an extended period of time,let the
water run to make sure that the water is clear and free of impurities.If this precaution is not
taken,there is a risk that the water inlet can get blocked and damage the appliance.
7.4 Hot Water Connection
The water supply to the appliance can also be
connected to the house's hot water line (centralised
system,heating system),as long as it does not
exceed a temperature of 60¡æ.
In this case,the wash cycle time will be shortened by
about 15 minutes and the wash efficiency slightly
reduced.
The connection must be made to the hot water line
following the same procedures as those for the
connection to the cold water line.
8.6Anti-Flooding Protection
T
he dishwasher is equipped with a system that
stops the supply of water in the event of a problem
with the water supply hose, or leaks within the unit,
in order to prevent damage to your home.If for any reason the box containing the electrical
components happens to get damaged, remove the plug for the appliance from the socket
immediately. In order to guarantee that the anti-flooding feature operates properly, the "A"
box with water supply hose must be attached to the water supply tap as shown in
Fig .1.No other type of connection is acceptable. The water supply hose must not, under
any circumstances, be cut, as it contains electrical parts which are live. If the length of the
hose is not adequate to make a proper connection, the hose must be replaced with one
which is long enough. This hose is available upon request from specialised retailers and
service centers.
7.5 Drain Hose Connection
Insert the drain hose into a drain pipe with a minimum diameter of 4cm,or let it run into the
sink, making sure to avoid bending or crimping it. Use the special plastic support that comes
with the appliance (see Fig.2). The free end of the hose must be at a height between 40 and
100 cm and must not be immersed in water.
Summary of Contents for WQP12-EFMS
