The drainage shall be smooth with the drain hose.
The height of the drain hose shall be less than 10cm,
or the drainage will not be smooth, and cost such long
time that the machine may stop at mid way.
Do not step on or press the drain hose.
If extra drain hose is needed, please make separate
purchase. The inner diameter of the extra hose shall
not less than 30mm, and the length shall not exceed 1.5m.
If the extra hose is too long,
cut it either at A or at B point.
A
B
<10cm
A
> 30mm
<1.5m
How to change the direction of the drain hose
Back
Front
The bottom plate
Soft object
Figure 1
Page 3
If the drain hose is too long, cut it at mid point. To make
smooth drainage, cut the front end of the hose slantingly.
Use this side groove after
change the direction.
Fix the drain hose
onto the groove.
Useage the drain hose
Before Using
Before Using
2.
Pull out the drain hose from the right side groove.
3.
Extend the drain hose out from the left side
4.
Install the bottom plate (method as stated in P3).
Lift up the machine gently.
1.
Disassemble the bottom plate.
Lean the machine down gently with the front
surface facing the ground. Loosen the eight
screws by a cross screwdriver.