Haier WD-8888-71, Service Manual, Page: 17 / 30

17
MAINTENACE SERVICE AND TROUBLESHOOTING
1. Trouble and solve method alarm
Phenomena The reason How to settle
The digitron displays E0. • The top lid is opened during
reserve procedure.
• Close the top lid.
The drainage cannot work,
or is too slow. The digitron
displays E1.
• Is the drain hose put down?
• Is the drain hose blocked
?
• Put down the drain hose.
Open and close the top
lid once.
• Clean the foreign
material. Open and close
the top lid once.
It stops running in midway.
The digitron displays E2.
• The top lid is not closed. • Close the top lid
The safety switch acts, and
the spinning cannot work.
The digitron display E3.
• Are the laundries put slantingly?
• Is the machine slanting?
• Reorder the laundries.
Close the top lid.
• The machine will start
running after 10 seconds
of being placed
horizontally.
The water filling does not
work, or is slow. After
about 15 minutes later,
the digitron displays E4.
• Is the water tap opened, or is
there water supply failure?
• Is the water inlet valve blocked?
• Is the water pressure too low?
• Open the water tap. Push
the Start/ Pause button
once.
• Clean the water inlet
valve then push the
Start/Pause button once.
• Push the start/Pause
button once
.
Not wash • Is there power failure?
• Is the power plug inserted tightly?
• Is the water level reached preset
position?
• Please use it when
there's power supply.
• Insert the power plug
tightly.
• Fill water to the preset
position
.
The machine
does not act
Not spin • Is the power plug inserted tightly?
• Is the top lid closed reliably?
• Are the laundries set flat?
• Insert the power plug
tightly.
• Close the top lid.
• Set the laundries flat.
There's abnormal sound
inside the machine
• Is the machine slanting?
• Are the laundries put slantingly
in spinning?
• Are there any foreign materials?
• Adjust the machine to be
even
• Reorder the laundries
and close the top lid.
• Remove the foreign
materials.