Haier UDW603, Instruction And Installation Manual

Page: 25 / 38

Half load function
The half load button “C” makes it possible to wash dishes using only the upper rack if there are not
enough dishes for a full load. This will allow you to save on water and energy consumption.
To select ½ load:
•
Select the required programme.
•
Press the ½ load button “C” and the ½ load indicator blinks.
•
Close the door and the programme starts automatically.
To cancel the ½ load:
•
Press the programme button “G” and hold for about 3 seconds.
Note: Please bear in mind that the amount of detergent used should be adapted for the ½
load function.
Memory function mode
If there is a power cut whilst the selected washing programme is active, the programme is not
cancelled. Once the machine is powered up again, the dishwasher will resume from the point it was
interrupted.
To cancel or modify a washing programme cycle:
•
To modify or cancel a washing cycle, it is necessary to re-set the previous programme by
pressing and holding selector button “G” for about 3 seconds. The appliance will emit a
short warning signal.
•
If the reset operation was successful, a drain cycle is started. Once the drain cycle is
complete, the dishwasher will wait for a new programming instruction.
•
A cycle that is underway can be modified only if it has been running for a short time. If the
appliance has been running for some time, the detergent may already have been used or
the wash water may already have been drained. If this is the case, the detergent dispenser
must be refilled.