Haier UDW603, Instruction And Installation Manual

Page: 24 / 38

End of programme
•
Six beeps will indicate that the wash cycle has finished and all the programme indicators will
illuminate.
Switching the dishwasher off
Several minutes after the programme has ended:
•
Open the door
•
Press the on / off button to switch the appliance off
•
Remove pots once they have cooled down sufficiently.
Interrupting the programme
A cycle that is underway can be modified if it has only been running for a short time. If the
appliance has been running for some time, the detergent may already have been used or the wash
water may already have been drained. If this is the case, the detergent dispenser must be refilled.
•
To cancel a programme that is underway, press programme button “G” and hold it for about
3 seconds.
•
Open the door, taking extra care to ensure that water does not squirt out. Do not open the
door fully until the spray arm has stopped rotating.
•
Once the door is opened, the dishwasher will beep ten times every 30 seconds until the
appliance is switched off.
•
If the appliance has already heated up or the hot water was switched ON and then the
appliance door opened, leave the door ajar for several minutes and then close. There is a risk that
the appliance door may open due to expansion if this important instruction is not adhered to.
Delayed start programming
You can delay the start of a programme in increments of 2 hours up to 12 hours.
•
Switch the dishwasher on.
•
Immediately press the delayed start button “J”. The delayed start indicator illuminates.
•
Press the delayed start button once or several times as required until the display shows the
delay time required. The delayed start wash cycle can be delayed for 2, 4, 6, 8, 10 or 12
hours.
•
To cancel the time delay setting, press the delay start button until the delay start indicator
light goes out.
•
Press programme “G” to select the required programme.
•
Once the dishwasher door is closed, the delay indicator “I” will blink and the countdown will
begin. The programme will start once the delay start indicator “I” goes out.