Haier TP180JEF, Manual For Installation And Operation

Page: 6 / 16

6
1.Take the water storage tank out of the packing case, unfasten the nuts and
the bolts on the both ends of the base of the tank.
2.Determine the location of the water storage tank.
3.The installers shall follow the instructions in the following assembly sketch map to fit the
tank frame and the tank strap together.
4.Remove the tiles from the place reserved for the water storage tank on the roof, then fix the
tank strap to the rafters, using self-drilling screws or stainless steel nails (or with embedded
expansion bolts).
5.Position the water storage tank in the correct configuration and well seated in the tank
frame.
washers fixed on
Note:
To avoid any scratch, the plastic film covering the tank shall be removed only upon completion
of the installation, and sharp tools such as a wallpaper cutter are prohibited from being used
to remove the film.
If your system is for flat roof, please refer to the Exploded View of System for flat roof
page 11 to 14.
on
A: The roof angle less than 20
°
B: The roof angle above 20
°
Self tapping screw
tank strap
bolts
tank strap
tank angle
fixing strap
tank strap
tank angle
Installation Introduction
Installation of Water Storage Tank