31-7000069 Rev. 1
21
CONNECTING DUCTWORK
3
Cabinet Front
Cabinet Bottom Shelf
Filler Block
Microwave Oven Top
Equivalent
to Depth
of Cabinet
Recess
Insert a self-aligning screw through top-center
cabinet hole. Temporarily secure the microwave
oven by turning the screw at least
two full
turns
after the threads have engaged
.
(It will be
completely tightened later.) Insert 2 self-aligning
screws (
1
\
4
ė¡"(û
2
1
\
4
ė
) through outer top cabinet
holes. Turn two full turns on each screw.
Tighten the three screws to the top of the
microwave oven. (While tightening screws, hold the
microwave oven in place against the wall and the
top cabinet.)
Install grease filters. See the Owner’s Manual
packed with the microwave oven.
5
4
Installation Instructions
1
2
Extend the house duct down to connect
to the exhaust adaptor.
Seal exhaust duct joints using duct tape.
House Duct
Self-Aligning Screw
ÖØÞ×ÝÝÑÎÖÒÌÛØàÊßÎØßÎ×
(cont.)
B6
B7
This distance
can NOT
exceed 2”
to ensure
proper
installation
MOUNT THE MICROWAVE
OVEN
B6
CAUTION
To avoid the risk of personal injury
(back injury or other injuries due to excessive
weight of the microwave) or property damage, you
will need two people to install this microwave.
WARNING
Risk of Electric Shock. Can cause
injury or death: If installing unit with metal cabinets,
cover the edge of the power supply cord hole in the
cabinet with the power supply cord bushing.
IMPORTANT:
If filler blocks are not used, case
damage may occur from overtightening screws.
NOTE:
When mounting the microwave, thread power
cord through hole in bottom of top cabinet. Keep it
tight throughout Steps 1–3. Do not pinch cord or lift
microwave oven by pulling cord.
Lift microwave, tilt it forward, and hook slots
at back bottom edge onto four lower tabs of
mounting plate.
Rotate front of microwave oven up against cabinet
bottom.
1
2
Power Cord
