31-7000069 Rev. 1
19
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws,
a hole large enough for the power cord to fit through,
and a cutout large enough for the exhaust adaptor.
B2
•
Read the instructions on the TOP CABINET
TEMPLATE.
•
Tape it underneath the top cabinet.
•
Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION
Wear safety goggles when drilling
holes in the cabinet bottom.
Installation Instructions
Back of
Mircrowave
Rotate 90°
Back of
Mircrowave
Fan Blades
Wires
CHECK BLOWER MOTOR
ORIENTATION
B3
1
3
2
4
ADAPTING BLOWER FOR
OUTSIDE VENTILATION
ADAPTING BLOWER FOR
OUTSIDE VENTILATION
B4
B4
The blower fan blade opening should be facing the top of
the microwave. If the fan opening is already facing the top
of the microwave, skip to Step B5. Otherwise, continue
to Step B4 to adjust the blower orientation.
Under the condition of the blower cover is installed on
the top of the microwave, remove the screw holding
the blower cover and remove the blower cover from
the blower plate by sliding it right.
Carefully pull out the blower unit. The wires will extend
far enough to allow you to adjust the blower unit.
Remove the 3 screws securing the blower plate, and
remove the blower plate from the outer case by sliding it
toward the back of the microwave and pulling up.
Roll the blower so that the fan blade openings are facing
the top of the oven. Place the blower back into the
opening.
NOTE:
Make sure the wires remain routed through the
openings in the motor frame. To avoid damage to the
fan motor wiring, insert motor carefully such that the fan
motor wiring does not contact the microwave power cord
bracket.
WARNING
Risk of Electric Shock
Can cause injury or death. Do not pull
or stretch the blower unit wiring. Make sure the wires are
not pinched.
Blower Cover
Blower Cover
Screw
Blower Plate
Blower Plate Screws
