INSTALLATION AND ACCESSORY PARTS
Connection between the water inlet hose jointer and the water faucet
3.Fasten the four screws evenly. See to Figure 4.
4.Take off the nameplate. Twist the fastening nut as per the indication of the figure to
seal up the outlet end surface of the faucet. See to Figure 5.
Remarks:
Before installation, the threading is 4mm above the upper surface of the nut. After
installation, the threading is 2mm above the upper surface of the nut. See to Figure 6.
Nut
About 4mm
before twisting;
about below 2mm
after twisting
Figure 5)
Figure 4
Figure 6
Screw
Screwdriver
Nameplate
Bushing
Figure 2
Figure 1
Figure 3
Slider
Water inlet hose jointer
Water inlet hose
Lock lever
1.Press the lower end of the lock lever and push down the slider. Take off the water inlet
hose jointer from the water inlet hose component. See to Figure 1.
2.Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet
hose on the faucet. See to Figure 2. (If the faucet is too large and the jointer can not be
set on the water faucet, please loosen the four screws and take out the bushing in the
jointer. The front end of the faucet must be smooth, otherwise it may leak water. See to
Figure 3.)
Connection between the water inlet hose and the washing machine
1.Do not take off the water absorption cushion.
Please check if the cushion is dropped or
damaged before each usage. If it happens
please contact our after-sale department
immediately.
2.Put the nut of the water inlet hose on the
valve jointer.
3.Fasten the nut. Swing it gently to confirm if
it's suitable.
Water absorption cushion
Nut of the water inlet hose
Jointer of the
water inlet valve
Model:HWM80-0566