7
8
It is required that the front end shall be longer than 10mm.
The exit end face of the faucet shall be flat and smooth.If not please file it to avoid leakage.
1.Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer
from the water inlet hose component. See to Figure 1.
5.Twist the fastening nut,See to Figure 5.After installation, the threading is less than 2mm above the
upper surface of the nut.See to Figure 6.
1.Do not take off the water absorption cushion. Please check if
the cushion is dropped or damaged before each usage.
If it happens please contact our after-sale department
immediately.
2.Put the nut of the water inlet hose on the valve jointer.
3.Fasten the nut. Swing it gently to confirm if it's
suitable.
1.Push down the slider. Insert the water inlet hose into the jointer.
2.Hang the lock lever to the jointer. Release the slider till a click sound is
heard
1.Swing the hose gently to confirm if it is fastened stable.
2.After installation, open the faucet to check if it leaks.
3.Do not bend the hose with overstrain.
4.Before each usage please check if the connection
between the jointer of the water inlet hose and the
water faucet, and the installation of the water inlet
hose are firm, so as to prevent dropping from
improper installation position.
1.Close the water faucet.
2.Press the locking lever. Push down the slider.Then pull off the water inlet
hose. If the machine is used frequently, the jointer of the water inlet hose
can be kept on the faucet to prevent damaging the fixing screw.
3.Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet hose on the
faucet. See to Figure 2. (If the faucet is too large and the jointer can not be set on the water faucet,
please loosen the four screws and take out the bushing in the jointer.The front end of the faucet must
be smooth, otherwise it may leak water. See to Figure 3.)
4.Fasten the four screws evenly. See to Figure 4.
About 4mm before twisting
About less than 2mm after twisting
2.Take off the nameplate. Make sure the threading is 4mm above the upper surface of the nut.See to
Figure 6.If the threading is less than 4mm above the upper surface of the nut.please loosen the
screws.
