4
11
Remaining Time
Program
Set the desired washing program,after seting,press the Start/Pause button,and washing machine begin to
run
.
Then hold the water level button and delay botton at the same time for more than 3 seconds, you will
hear three beep sound,digital tub display“CL”,and the child lock will activate.
The circular indicator light
under right corner of the digital tube will flash,All of the bottons are locked and have no function.
Wash
Rinse
Spin
Tub Dry
Normal
Soak
Soft
54
43
39
48
Normally on
Flash
(Take example for HWM70-12688NZP)
Time
Release the child funtction:
Press the water level button and delay botton at the same time for more than
3 seconds,After three beep sound,the child lock function is released,
or the machine will set to child lock
function automatica
l
ly for using every time.
Explanation of Buttons
On: indicate the program about to run,or indicate the selected mode or indicate the water level
Flashing: indicate the running program, or indicate the selected mode or indicate the water level
Off
Indicator mode and meaning
It displays total remained time during the running program
(min).it displays the remained reserve time during delay
program(hours) .
It displays abnormal symbol in abnormal situation.(See to Page14)
It displays "--" during detecting,the actual washing time might be different with display
time under the condition of different water presure,different cloth material and different
loading cloth.
Child lock funtion
The function is intended for children safety and preventing the washing program from accidental changes
by children
Note: if you open the lid when the child lock activates,digital tube displays “E2”,beeps and stops
running; if the safety can be sured and you need to go on with running ,you need close the lid,press
the water level button and delay botton at the same time for more than 3 seconds to released the
child lock function and then continue running,or the washing machine will drain after 10 seconds,and power
will be off after 10 minuters.
Do not let the machine share one receptacle with other electric appliances. If the plugging into the
receptacles loose, do not use the plug any more.
In case the washing machine is installed on ground
with carpet, do not block the ventilation hole
with carpet. Ensure carpet does not obstruct the
opening in the bases.
Do not put the machine at damp place like the
bathroom. Never wash it with water. Do not put wet
laundries on the control panel.
Do not use water hotter than 50 °C.
Do not wash water-proof laundries like the raincoat,
bike covers etc. to avoid abnormal vibrations in
spinning. Wash the clothes that can float on the
water surface easily, please be careful especially,
for fear damage.
The washing machine must be positioned so that
the plug is accessible. Be sure to pull the plug off
and close the water faucet in following cases: power
failure, delivering the machine, setting the machine
idle or cleaning the machine.
Do not plug or pull the power plug with wet hand.
Do not bend ,extend, twist, bind by force. Do not press or nip it with weight.
Keep the pin of the power plug clean, if the power plug is polluted with dust,
please wipe with dry cloth carefully.
If the supply cord is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
Please plug the power cord on special receptacle
with rated voltage.Be sure to use single-phase three
pins receptacle.The earthing terminal of the receptacle
must be earthed reliably. If possible,please adopt
electric leakage protector.
