Haier HWM65-187S, Service Manual

Page: 10 / 17

Dismantling and installation of the base frame
Dismantle the back cover. Loosen the wires. Loosen the
fastening screw of the spin tub shaft. Separate the shaft
from the brake wheel. Loosen the brake hook. Take off
the brake cable frame from the installation groove of the
twin-tub. Take off the V-belt. Take out the drain hose from
the groove of the base frame. Loosen the fastening screw
between the base frame and the cabinet to dismantle the
base frame component.
Dismantling and installation of the bearing seat
Once the bearing seat is taken off, it can not be utilized again. Therefore do
not dismantle
it as far as possible. In case that it has to be replaced, please dismantle it as
per following
sequence, then install a new bearing seat.
Dismantle the spin tub . Then pull out the bearing seat.
Cut off the inner lining claw inside the bearing seat with cutting pliers and
take it out.
Install the new bearing seat and inner lining.
Dismantling and installation of the bearing seat
Once the bearing seat is taken off, it can not be utilized again. Therefore do
not dismantle
it as far as possible. In case that it has to be replaced, please dismantle it as
per following
sequence, then install a new bearing seat.
Dismantle the spin tub . Then pull out the bearing seat.
Cut off the inner lining claw inside the bearing seat with cutting pliers and
take it out.
Install the new bearing seat and inner lining.
Figure 9
Right
Wrong
9
INSTALLATION AND ACCESSORY PARTS