The largest allowable slope of the shank base of the machine is 2
.The slanting or rough ground will result in
unstable running or stoppage of the machine. Please adjust it with following methods:
Confirm it's horizontal:
Hang the lead line to check if it is
horizontal.
Adjust the adjustable leg:
Adjust the Installation position
Screw
Back
Front
bottom plate
Soft object
Fasten
Loosen
High
Low
the adjustable nut
the adjustable feet
Please install and adjust the machine according to the requirement of the mannual.
It is very important to your security and correct operating the machine.
Before Using
Before Using
Installation and adjustment
1 .To twist the adjustable leg, please first lift up the
side of the leg slightly, loosen the adjustable nut,
and twist the leg.
2 . After adjustment, fasten the nut.
After opening the package, please lean the washing machine
gently down on soft items (like towel cloth,blanket, etc.). Install
the bottom plate to the bottom of the machine with eight screws
by a cross screwdriver, then lift the machine up gently.
See to the figure:
Push the "Start/Pause" button
5 Close the lid
6 Finish washing
After Finishing wash
alarm automatically
After finishing wash
it'll alarm automatically
As the top lid opened ,the Washer will automatically give an alarm
and stop running , then drain automatically after 15s ,exclusively
during supplying water and rinsing.
Using process
Using process
* Total time: including the normal water inlet time and drain time. The total washing time may be influenced by
the water inlet pressure and water level.
* Spin time: From the moment the intermittent spinning starts to the moment it stops running (the time displayed
on spin digitron is from intermittent spinning to the moment before inertia spinning; the time displayed on the
time remain digitron is the total remaining time)
* In selecting "super quick" program, the washing machine will set the complete procedures of water level
selectior, washing, rinsing and spinning automatically.
Push the "reserve" button to select suitable reserve wash program
Start
Pause
After switching on the power, the reserve program is set to off mode automatically. If you need to set the washing
procedure to be finished at reserved time, please push the " reserve " button to set the reserve wash program.
Refer to reserve button in Page 11 for selection
When the "reserve" function is activated, the indicator light of the program you have set
will be off. The "reserve (hour)" and "time remain" indicator lights will be on. During
reserve procedure, push the "reserve" button to display the reserve mode.
To change the running program or cancel the reserve setting, you
need to switch off the power and make new selection.
T
he washing will be finished after 18 hours.
Confirm the operation of reserve program
Reserve
Time
( remain)
Reserve
(hour)
Page
Install the inner cover
Install the lint filter
Install the lint filter in the balance ring.
Install the bottom plate
Inner cover
Inner cover shaft
Outer tube cover
Section
•
enlarging
Push
Outer tube cover
shaft groove
1.Open the top lid of the washing machine.
2.Put the inner cover component on the outer tub cover,
aiming the inner cover shaft to the installation hole of the
corresponding outer tub cover shaft groove.
3.Firstly insert the inner cover shaft of one side into the
corresponding outer tub cover shaft groove, then push
the another inner cover shaft into the corresponding outer
tub cover shaft groove. Please install to designated position
to guarantee there are no dropping or abnormal sound in
opening and closing of the inner cover, and the operation
shall be smooth. Do not dismount the inner cover component
after washing.
Dismantle
Install
lint filter
