EN
3-Control panel
11
3.4 Detergent drawer
Open dispenser drawer, the following components can
be seen (Fig. 3-5):
1: Compartment for powder or liquid detergent
2:
Detergent flap slector, lift it up for powder detergent,
keep it down for liquid detergent.
3: Compartment for softener.
4: Lock tab, press it down to pull out dispenser drawer
The recommendation on the type of the detergents
is suitable for the various washing temperatures.
Please refer to the manual of detergent(see P11).
3.7 Child lock
Choosing a programme and then start, press button
“Delay” and ”Dry level” ( Fig .3-13) for 3 seconds simultane-
ously to block all panel elements against activation, panel
display
.For unlocking please press again the two but-
tons.The child lock indicator lights up when the child lock
works. Feature is optional when the machine is running.
The display shows
(Fig. 3-14) if a button will be
pressed, when the child lock is activated. The change is not
running. .
3-11
3-12
3-9
3-10
3-13
3-12
Dry level
3.5.3 Function button“Temp.“
Press this button (Fig. 3-9) to change the washing tem-
perature of the programme. If no value is illuminated
(the display”-- °C“) the water will not be heated.
3.5.4 Function button“Speed“
Press this button (Fig. 3-10) to change or deselect the
spin of the programme. If no value is illuminated the dis-
play“
“ the laundry will not spin.
3.5.5 Function button“Extra Rinse“
Press this button (Fig. 3-11) to rinse the laundry more
intense with fresh water. This is recommended for peo-
ple with sensitive skin. By Pressing the button several
times zero to three additional cycles can be selected.
They appear in the display with P--0/P--1/P--2/P--3.
Diff erent programme optiones are diff erent.
3.6 “Start/Pause“ button
Press this button (Fig. 3-12) gently to start or interrupt
the current programme. During programme setting and
during programme run the LED above the button is shi-
ning, or if interrupted blinking.
3-14
Note:
Procedure to check the number of cycles that the machine has run
Procedure: under standby mode, select “Cotton” programme fi rst, then press “Temp.”
and “Speed” at the same time, it will display the number of running cycles for 2 seconds,
and then back to standby interface. The cumulativer running cycles will add 1 after the
programme ends. The running cycles will be displayed in hexadecimal if it is over 9999.
