11-Installation
NZ AU
30
11.1 Preparation
▶
Take the appliance out of the packaging.
▶
keep them out of childrens reach. While opening the package, water drops may be
seen on plastic bag and porthole. This normal phenomenon results from water tests
in the factory.
Note: Packaging disposal
11.2 OPTIONAL: Install noise reduction pads
1.
2.
3.
11-1
noise reduction pads.These are used for reducing
noise(Fig. 11-1).
.
2
3.
Take out the noise reduction pads and remove the
;
paste around
the bottom
;
the noise reduction pads under the
washing machine cabinet as shown in Figure 3(two
longer pads in position 1 and 3, two shorter pads in
position 2 and 4). Finally set the machine upright again.
11.3 Dismantle the transportation bolts
The transportation bolts are designed for clamping
anti-vibration components inside the appliance during
transportation to prevent inner damage.
1.
2.
Remove all 4 bolts on the rear side and take out
plastic spacers (Fig. 11-2)(Fig. 11-3).
Fill left holes with blanking plugs (Fig. 11-4)(Fig. 11-5).
11-2
11-3
11-4
11-5
Keep all packaging materials out of children's reach and dispose them in an
environmentally friendly manner
Lay the washing machine down to its side,porthole
pointing upwards,bottom side towards operator.
