10- Installation
EN
28
10.2 Adjusting the bottom cover board
um-plastic board
,
and noise reduction pads.
These are used for reducing noise. (Fig. 10.2)
3.
Note: Packaging disposal
Keep all packaging materials out of children´s reach and dispose them in an environmen-
tally friendly manner.
10.1 Preparation
▶
Take the appliance out of the packaging.
▶
Remove all packaging material including polystyrene base, keep them out of childrens
reach. While opening the package, water drops may be seen on plastic bag and port-
hole. This normal phenomenon results from water tests in the factory.
10.3 Dismantle the transportation bolts
The transportation bolts are designed for clamping
anti-vibration components inside the appliance during
transportation to prevent inner damage.
1. Remove the back cover (Fig. 10-3.1).
2. Remove all 4 bolts on the rear side and take out
plastic spacers (A) from inner side of the machine
(Fig. 10-3.2).
3. Replace back cover by inserting it in the two gaps
its convexity is facing out (Fig. 10-3.3).
4. Fill left holes with blanking plugs (Fig. 10-3.4).
Note: Keep in safe place
Keep the transportation bolts in a safe place for later
reinstall the bolts.
1.
2.
3.
10.2
A
10-3.1
10-3.2
10-3.4
10-3.3
Place the calcium-plastic board
2. Lay the washing machine down to its side, porthole
pointing upwards, bottom side towards operator and
screw off the four bolt.
towards inside, screw the bolts through the four holes
on
the board on to the tub firmly.
pads and remove the
double-sided adhesive prot
ective film; the noise redu-
ction pads under the washing machine cabinet as
shown in Figure 3.(two longer pads in position 1 and 3,
two shorter pads in position 2 and 4). Finally set the
machine upright again.
2x
2x
1.
-
Warm tip:
Noise reduction pad is optional , could help to reduce
noise , please assemble it or not according to your
own demand.
Summary of Contents for HWD100-BP14636
Page 1: ...EN User manual Washer dryer HWD90 BP14636 HWD100 BP14636 ...
Page 34: ......
Page 68: ...0020506943JU ...
