Haier HW80-B14876, User Manual, Page: 28 / 32

9-Installation
28
Foll
●
owing connections are possible:
9.6.1 Drain hose
●
to sink
Hang the drain hose with the U-support over the
edge of a sink with adequate size (Fig. 9-10).
ping.
9.6.2 Drain hose
●
to waste water connection
The internal diameter of the stand pipe with
vent-hole must be minimum 40 mm.
Put the drain
●
hose for approx. 80 mm in the
wastewater pipe.
(Fig. 9-11).
9-10
9-11
CAUTION!
●
Drain hose is not to be extended. If necessary contact after sales service.
9.6.3 Drain hose to sink connection
The junction must lie above the siphon
A spigot connection is usually closed by a pad
That must be removed to prevent any disfunc
tion (Fig. 9-12).
Secure the drain hose with a clamp.
9-12
9.6 Drain Water Connection
WARNING!
Use only the supplied hose set for the connection.
Never reuse old hose sets!
Only connect to cold water supply.
Before connection, check whether the water is clean and clear.
Protect the U-support sufficiently againsy slip-
Attach the U-support and secure it sufficiently
The drain hose should not be submerged in water and should be securely fixed
and leak-free.If the drain hose is placed on the ground or if the pipe is at a hei-
ght of less than 80cm, the washing machine will continuously drain while being
filled(self siphoning).