10-Installation
EN
28
10.8 Electrical Connection
Before each connection check if:
▶
power supply, socket and fusing are appropriate to
the rating plate.
▶
the power socket is earthed and no multi-plug or
extension are used.
▶
the power plug and socket are strictly according.
Put the plug into the socket (Fig. 10-13).
WARNING!
▶
dry and leack free!
▶
Take care these parts are never to be crushed, kinked, or twisted
▶
If the supply cord is damaged, it must be replaced by the service agent (see warranty
card) in order to avoid a hazard. .
Note: Hygiene
-
nance run programme HYGIENE with no load and small amount of detergent in wash-
ing agent compartment (2) or with special machine cleaner to remove possibly corrup-
tive residues.
10-13
10.7 Fresh Water Connection
10-12
10-11
Make sure that the gaskets are inserted.
1.
Connect the water inlet hose with the angled end
to the appliance (Fig. 10-11). Tighten the screw
joint by hand.
2.
The other end connect to a water tap with a 3/4“
thread (Fig. 10-12).
Note: Aqua-stop-system:
Some models are equipped with an aqua-stop inlet hose (B).The aqua-stop system
protects against water damage by automatically cutting the fresh water supply in case
of a leaking hose. This is indicated by a red marker (C). The hose must be replaced.