Haier HW60-1081, Service Manual

Page: 14 / 21

Service Manual
Model No:HW60-1281S/1081
Issue
Rev.
12
(Attention:The packing bolts and rubber hose should be kept
in a safe place for later use)
Adjusting the washing machine 8.3
There are adjustable feet under the bottom of the washing
machine. Before use, the washing machine should be
adjusted, as shown in Fig.3, so that it is level.
Joining the InletHose to the Washing 8.4
Machine
Connect the nut on the inlethose to the connector on the water valve.
The height of the drainage outlet must be 80-100 cm. To prevent the
drainage hose from dropping of
it to the drainage hose clip at the
back of the washing machine.
Use the drainage holder to keep the end of the drainage hose
retained and to prevent the
of water. It is recommended that
drainage hose tensions not be used; if an tension is needed,
please consult a service man. The additional hose should be no
Note: The drainage hose should not be submerged in water and should be securely
and leak-free. The appliance is to be connected to the waster mains using new hose-sets and that old
hose-sets should not be reused.
Connect of Power Supply 8.5
Before connecting to the power supply, check:
The socket is adequate for the ma imum power of the washing machine (For safety,
fuses in the power circuit should be rated no less than 15 A).
The voltage should meet there quirement.
The power outlet should be capable of accepting the washing machine plug. The
washing machine must be earthed before use.
Supplementary earth cable should not be necessary if the socket is connected to the
earth.
Supplementary earth cable should be installed on the upper back of the washing
tie-in of water inlet valve
absorb water gasket
nut of water
inlet tube