![background image](http://html.mh-extra.com/html/haier/htn20r15/htn20r15_service-manual_138148029.webp)
B2/UIN 48
2
nd
B input / U (B-Y) input / P
B
input
BCLIN 49
beam current limiter input
BLKIN 50
black current input / V-guard input
RO 51
Red output
GO 52
Green output
BO 53
Blue output
VDDA 54
analog supply of Closed Caption decoder and digital supply of TV-processor (3.3 V)
VPE 55
OTP Programming Voltage
VDDC 56
digital supply to core (3.3 V)
OSCGND 57
oscillator ground supply
XTALIN 58
crystal oscillator input
XTALOUT 59
crystal oscillator output
RESET 60
reset
VDDP 61
digital supply to periphery (+3.3 V)
P1.0/INT1 62
TV/AV (AV1) / AV2 /S-VHS mode Output.
P1.1/T0 63
TV/AV (AV1) / AV2 /S-VHS mode Output.
P1.2/INT0 64
Remote control signal input.
Note
1. The function of pin 20, 28, 29, 31, 32, 35 and 44 is dependent on the IC version (mono intercarrier FM demodulator /QSS IF
amplifier and East-West output or not) and on some software control bits. The valid combinations are given in table 1.
2. the vertical guard function can be controlled via pin 49 or pin 50. the selection is made by means of the
IVG bit in subaddress 2BH.
TABLE 1
IC version
FM-PLL version
QSS version
East-West
Y/N
N
Y
N
Y
CMB1/CMB0
bits
00 01/10/11 00 01/10/11
00
01/10/11
00
01/10/11
AM
bits
- -
-
- -
0 1 - 0 1
Pin 20
AVL EWD
AVL
EWD
Pin 28
AUDEEM
SIFIN1
Pin 29
DECSDEM
SIFIN2
Pin 31
SNDPLL
SIFAGC
Pin 32
SNDIF(1) REFO(2) AVL/SNDIF(1)
REFO(2) AMOUT REFO(2)
AMOUT REFO(2)
Pin 35
AUDEXT
AUDEXT
QSSO
AMOUT AUDEXT QSSO
AMOUT
Pin 44
AUDOUT
Controlled AM or audio out
Note
1. When additional (external) selectivity is required for FM-PLL system pin 32 can be used as sound IF input. This function is
selected by means of SIF bit in subaddress 28H.
2.
the reference output signal is only available for the CMB1/CMB0 setting of 0/1. for the other settings this pin is a switch
output(see also 5 table 67).
Circuit Explanation
Summary of Contents for HTN20R15
Page 11: ......
Page 26: ...PCB Diagram 3 PCB Diagram ...