Haier HM1200TX, Instructions For Installation And Operation Manual

Page: 6 / 22

Connect the plug to a socket provided with efficient
earthing. Or use the spare earthing wire supplied
together with the machine and the earthing terminal
located on the left-upper corner of the back of your
machine (Warning: this appliance must be earthed as a
safety measure according to the law). Make sure that
the voltage and frequency available correspond with
the values stated on the data plate located at the back of
the machine and that the electric system is
dimensioned to withstand the maximum current shown
on the data plate. If the socket the machine is
connected to does not correspond with the plug,
replace the plug with a suitable one and avoid using
adaptors or shunts since they could cause overheating
and burn out.The spare eathing wire is absolutely not
allowed to be connected to water pipe,heating pipe or
other kinds of pipes.
Installation
Electric
connectio
Connection
of tap and
Loading
Hose
Connect the inlet hose to a cold water tap with a 3/4
gas threaded opening, and fit the filter and the rubber
gasket supplied with the washing machine. Check that
it is tightly screwed to the tap (Fig. 3).
If the water piping is new or has not been used for a
long time, before making the connection, let the water
run until it is clear and free from impurities.
This step is necessary to ensure that the incoming
water does not clog and possibly damage the machine.
Fig. 3