5
5
5
5
�
6.Do not store explosive substances such as aerosol cans with flammable propellant in this appliance.
�
7.If the supply cord is damaged
，
it must be replaced by the manufacturer
，
its service agent or
similarly qualified persons in order toavoid a hazard.
MAINTENANCE
MAINTENANCE
MAINTENANCE
MAINTENANCE
�
Remove power plug or disconnect from the mains before performing any maintenance or
servicing the product.
�
Never use detergent or chemicals harmful to health to clean the water tanks.
�
Do not directly spray water on the surface of the product.
�
Wipe the front and back of the product with water-soaked soft cloth.
�
If dust of other exterior substance has accumulated on the condenser, wipe off with
water-soaked soft cloth.
�
After cleaning the product, completely dry it. Fill the water to the tanks until waters
comes out of the hot water faucet, then connect the electric power plug. If the surface of
the electric heater in the hot water tank is deposited by water deposition, heating capacity
will decrease. Fill hot water tank with aqueous solution of 2% aitric acid and keep for
about two hours then cleaning. If the problems can not be solved, contact your dealer or
the Service Center of our company.
TROUBLESHOOTING
TROUBLESHOOTING
TROUBLESHOOTING
TROUBLESHOOTING GUIDE
GUIDE
GUIDE
GUIDE
PROBLEM
PROBLEM
PROBLEM
PROBLEM
POSSIBLE
POSSIBLE
POSSIBLE
POSSIBLE CAUSE
CAUSE
CAUSE
CAUSE
Water dispenser does not operate.
Not plugged in.
The circuit breaker tripped or a blown fuse.
Water cooler is not cold enough.
Check to be sure the cold switch on the back is ON.
The water dispenser does not have the correct
clearances.
Water dispenser hot water is not hot enough.
Check to be sure the hot switch on the back is ON.
Compressor turns on and off frequently.
The room temperature is hotter than normal.
The temperature control is not set correctly.
The water dispenser does not have the correct
clearances.
Vibrations.
Check to assure that the water dispenser is level.
The water dispenser seems to make too much
noise.
The rattling noise may come from the flow of the
refrigerant, which is normal.
As each cycle ends, you may hear gurgling sounds
caused by the flow of refrigerant in your water
dispenser.
Contraction and expansion of the inside walls may
cause popping and crackling noises.
The water dispenser is not level.
Bottle feels warm.
The water system is overfilled. Dispense Cold water
until air is released into the bottle.
Water bottle is hot.
Water is boiling in the hot tank and bubbling up into the
bottle. Press the hot dispenser button until water flows
to remove air from the hot tank.
