Haier HD90-A636, User Manual

Page: 22 / 34

Care and cleaning
GB
22
Fiber abrasion results because of wearing and washing
the laundry. These fibers (fluff) will be collected during
the drying process in the lint filter. The lint filter in the
filling opening must be cleaned after each drying cycle
to ensure proper air circulation. The shining LED
will remind you.
1. Remove the lint filter from the drum (fig.: 36).
2. Open the lint filter (fig.: 37 and 38) and remove all
lint residuals. By using a damp cloth or moistened
hand the fluff will be remove easily.
Detergent residue may be form coating at the fluff
filter. In this case, the filter must be cleaned with
warm water and a soft brush.
3. Reinstall the cleaned lint filter in the tumble dryer
(fig.: 39). The symbol only switches off after the
appliance was turned off.
4. Occasionally the fluff around the housing of the
filter as well as on the seal should be removed (fig.:
40).
WARNING!
Do not operate the dryer without or with damaged lint or condenser filter.
The tumble dryer is equipped with a filter system to
protect the heat pump from dirt. This is located in the
base of the appliance. Gradually also at this place larger
amounts of fluff will be accumulated and may affect
the proper function of the appliance. The shining LED
will remind you.
1. Open the Service door (fig.: 41).
2. Open the four levers (fig.: 42).
3. Pull out the condenser filter from its housing (fig.:
43).
4. Remove the rear filter screen (fig.: 44/45).
5. Clean the condenser filter from any residuals with
a damp cloth or moistened hand. If the filter is very
dirty, it can be cleaned under running water.
6. Reinstall the rear filter to the condenser filter (fig.:
46).
7. To reinstall the condenser filter, follow the above
steps 3 to 1 in reverse order.
Clean the lint filter
36
37
38 39
40
Clean the condenser filter
41 42
43 44
45
46