Haier HBS1000TXV, Service Manual

Page: 11 / 30

Front Load Washing Machine Model:HBS800/1000TXV
Page 10
１
０
０
ｃ
ｍ
８０
ｃｍ
The height of the drainage outlet must be 80-100cm. To prevent the drainage hose from dropping off,
fix it to the drainage hose clip at the back of the washing machine.
Before connecting to the power supply, check:
Joining the Inlet Hose to the Washing Machine
Connect of water inlet valve
Ｗａｔｅｒ ｉｎｌｅｔ ｈｏｓｅ ｏｕｔ
1. Connect the nut on the inlet hose to the connector on the water valve.
２． Ｔｉｇｈｔｅｎ ｔｈｅ ｎｕｔ ｔｏ ｓｅｃｕｒｅ ｔｈｅ ｈｏｓｅ
Installation
Ｄｒａｉｎａｇｅ Ｈｏｓｅ
Use the drainage holder to keep the end of the drainage hose retained and to prevent the outflow
of water. It is recommended that drainage hose extensions not be used; if an extension is needed,
please consult a serviceman. The additional hose should be no more than 250cm (overextended
hoses could lead to siphonage). Note: The drainage hose should not be submerged in water and
should be securely fixed and leak-free.The appliance is to be connected to the waster mains using
new hose-sets and that old hose-sets should not be reused.
Connecting to the Power Supply
The socket is adequate for the maximum power of the washing machine (For safety, fuses in the power circuit should be rated
for no less than 15A).
The power outlet should be capable of accepting the washing machine plug. The washing machine must be earthed before
use.
Supplementary earth cable should not be necessary if the socket is connected to the earth
Supplementary earth cable shoulde be installed on the upper back of the washing machine andconnected to an earth if the
power supply socket has no earth connection
The voltage should meet the requirement.