STEP 1
DO NOT TURN ON GAS YET
Connect the CO2 regulator to tank by
screwing regulator nut onto threaded
tank valve. HAND TIGHTEN
ONLY – it is not necessary to use
a wrench to tighten this nut.
At this point
make sure that both the shut off (black)
valves are in the off (sideways) position.
STEP 2
Attach one red gas hose to each of the shut off valve
outlets on the bottom of the regulator and clamp tight
using two of the white squeeze clamps provided.
S
T
E
P
3
Attach the other end of each red
gas hose to the LARGER of the two
hose barbs on the keg coupler
and secure with the remaining two
white squeeze clamps.
STEP 4
Locate the two clear hoses from the draft arm installed previously.
(These should be inside the refrigerator at this point). Attach one clear
beer hose to the SMALLER hose barb on each keg coupler being cer-
tain to push the hose completely onto the barb. This connection does
not require a white squeeze clamp.
9
English
C02 Regulator
C02 Cylinder
Clamp
Red
Hose
Large Barb
Keg Coupler
Clear Hose
Small Barb
