1. For horizontal water heaters, it is recommended to fix the feet of the heater onto the foot
foundation with embedded iron parts or make a concrete brick with expansion bolts and
then fix the feet of the heater to the expansion bolts.
2.Adjust the height of the frame by the hard waterproof cushion to keep the horizontal tank
and each foot evenly weighted.
Please see the related paper in the frame package for the diagram of the frame and
packing list.
1.Unpacking the tank, rip off the protection film.Uninstall the nut and cushion.
2.Place tank onto tank bracket cradle,inserting protruding bolts into holes,fasten with nuts.
1.Pipe fitting is connected to water pipe with
asolderless connection.
2.Overflow pipe and water inlet pipe both use
solderless structure. To install, use a wrench to
secure the water tank pipe head. In ordertoavoid
damaging the seals, do not rotate water tank pipe
head and do not apply force along the axial direction
of the pipe.
3.When installing the water inlet and outlet pipe,first
use a wrench to secure the water tankpipe head,
then unscrew the plastic cap and use inner ratchet
teeth to directly connect tothe PEX pipe. Before
installation, check that the gasket ring of the water
inlet and outlet pipe is intact.
Notice:
1.Rip off the protection film after installationto avoid the destroy of the tank,and please
do not use the sharp tool.
2.Leave nuts loose since some adjustment may be necessary after fitting tubes.
3.When assembling the water tank, keep the center line of the vacuum tube connecting
holes parallel with the diagonal pillar of bracket.
4.The inlet and outlet of the water tank can be also used as the drain.
Notice:
1.Make sure that the feet all closely contact the supporting floor without foot suspension to
avoid damage of the product due to frame deformation.
2.Please use the steel wire to firmly fasten the tank and frame if in a location where
typhoons frequently occur.
3.The water heater shall be stably and firmly installed to avoid severe damage or accident
due to harsh weather conditions.
Installation instructions
Tank installation
Installation of Solderless Pipe Head
Frame assembly
Frame fastness
Water inlet
and outlet pipe
Inner wall
Outer
casing
Sensor pipe
During installation, use a wrench
to fasten the tank pipe end
Do not rotate the
tank pipe ends
Do not apply
force along the
axial direction
of the fittings
