– 73 –
(Continued Next Page)
Fault
Code
Description
Trigger Condition
Action
8
Pressure Sensor
Loss
Determines if appropriate
pressure changes
are seen during fill. It
assumes there is a
pressure leak, a clog in
the pressure hose/system
delaying the increase in
pressure, or a significant
amount water leaking out.
• Check to make sure house water
supply valves are turned on.
• Check water valve operation.
• Check pressure tube for pinches where
it goes through top cover grommet.
• Use pressure sensor test 10 to ensure
correct pressure sensor operation.
• Check pressure tube for trapped water.
• Ensure pressure chamber port is free
from obstruction using drill bit size 1/16-
in. by hand so as not to drill through the
inner wall.
9
Door Switch
Redundancy
Three cycles have been
completed without any
door opening.
• Open and close the door to clear the
fault.
• Check harness and connectors that go
to the door switch.
• Use test 13 to ensure system can
detect the correct door state with the
Spin and Rinse LED's.
• Consumer education that four cycles
cannot be run back-to-back without
opening and closing the door.
• If the fault will not clear, replace the
door lock.
15
Water Temp
Sensor Invalid
The thermistor is
disconnected, not
present, or has failed.
• Run Service Mode heater and
thermistor test 20 to verify heater and
thermistor.
• Check thermistor resistance from
connector J701 on the control board.
Validate the resistance matches the
table in mini-manual.
• Check the heater resistance from
connector J503 on the control board
from pin 4 to 5.
• Check wiring harness and connections.
• Replace thermistor or heater if
resistance is out of spec.
17
Dry Load Sense
Timeout
Dry load sense times out
and moves to the next
part of the cycle selected.
This occurs when the
washer is not reaching
the target speed within a
defined time limit for the
load type selected.
• Check for water in the bottom of the
tub. If so, drain and try cycle again.
• Check the basket for excessive friction.
Basket should spin freely. If not, find
source of friction and remove it.
• This can also happen if a cycle is
started with wet clothes.
• Consumer education to doesn’t load the
washer with wet clothes.