English
Instruction for use
5
22
Place the appliance on an even and non-skid surface.
Leave a space of at least 15 cm between the foremost edge of the worktop and the front of
the oven door .
Install the oven in a place where it is protected against splashing water or dripping liquids.
Never operate the appliance outdoors. Sunlight and humidity may impair operational safety.
Never expose your microwave oven to direct sunlight (overheating hazard).
Do not install the appliance in the immediate vicinity of heat sources such as radiators or cookers.
For some models a built under - mounting set is commercially available. Please ask your dealer or
the respective customer support service.
The rating plate with technical specifications is located on the cabinet, at the rear of the oven.
Your appliance must be connected to a power socket with grounded connection, which complies with
the respective regulations and has been installed by authorised specialists.
The appliance must not be built into a cupboard.
The oven must not be built in underneath a panel or a cupboard.
It must be stable enough to easily support the appliance even if the oven contains goods.
You will thus prevent the appliance from tilting forward when the door is open.
During operation clouds of steam escape through the air vents of the appliance and it may get very hot
within the space of the above mentioned minimum clearances. The microwave oven should thus be
installed so that no objects sensitive to heat or moisture are located near the minimum clearances.
Avoid any possible overheating of the oven caused by unintentionally covering or sealing the air vents.
When in operation the base of the oven may become very hot. The worktop must thus be accordingly
heat-resistant.
CAUTION!
4 Rating plate
5 Plugging in your appliance
When you install your oven, make sure there is adequate ventilation for your oven by leaving at
least 10 cm of space behind, and
on the sides of the oven and
of space above the oven
and 85 cm of the floor.
5 cm
30 cm
30cm
above
10cm
behind
5cm
on the side
85cm
on the floor
Before plugging the appliance into the wall socket, make sure that the voltage(V) and fuse amperage
English
Instruction for use
After a long time of use, your microwave oven should be cleaned regularly to prevent grease
and food particles from building up, with the
Auto Clean
function, you can clean the oven cavity easily.
in the following, we will show you how to use this feature. before you use it, be sure to take all the
food or water out of the cavity except the
TURNTABLE
COUPLER
and
ROLLER RING
1.Press / key.
2.Close the door, press the
Auto Clean
button the oven works automatically.
When cooking has finished, the oven will beep five times and display
End
for ten seconds. Then
The oven will be on call(
display the clock
).never open the door at this time because the it is very hot
in the oven, after about then minutes later,
Always use oven gloves, you can open the door, take the
accessories out, Clean the inside surfaces with a soft cloth and warm, Rinse and dry.
Auto clean
You will hear one beep, the set is ok.
You should set the programme orderly (
CP-1,CP-2,CP-3,CP-4,CP-5
).
Use the memory
1.Press / key.
2.Press the
MEMORY
button once
3.Turn the
DIAL knob
, until it diisplay
CP-1.
4.Press
the
DIAL knob
. it works.
MEMORY
MEMORY
Set the memory
1. Press / key.
2. Press the memory button until it dispaly
CP-X
( X is number from 1 to 5)
3.
4. Turn the
Cooking Control knob
to
the
( ) symbol, dispaly:
P100
5.
Turn the
DIAL knob
until it display
P 80.
6
DIAL
knob until it display
10:00.
8.
Press the
DIAL knob.
Turn the
DIAL knob
until it display
CP-1.
.
Press
the
DIAL knob.
7.
Then turn the
9.
Then press the memory for about five seconds, release it , the menu has been set.
When cooking has finished, the oven will beep five times and display
End
for ten seconds.
Then The oven will be on call(
display the clock
),please wait for a few minutes after the ferment.
_
+30s
C
+
_
+30s
C
+
_
+30s
C
+
_
+30s
C
+
_
+30s
C
+
/
