background image

English

Place the appliance on an even and non-skid surface.

Leave a space of at least 10 cm between the foremost edge of the worktop and the front of
the oven door .

Install the oven in a place where it is protected against splashing water or dripping liquids.

Never  operate the appliance outdoors.  Sunlight and humidity may impair operational safety.

Never expose your microwave oven to direct sunlight (overheating hazard).

Do not install the appliance in the immediate vicinity of heat sources such as radiators or cookers.

For some models a built under -  mounting set is commercially  available. Please ask your dealer or
the respective customer  support service.

The rating plate with technical specifications is located on the cabinet, at the rear of the oven.

Your appliance must be connected to a power socket with grounded connection, which complies with
the respective regulations and has been  installed by an authorised specialists.
Before plugging the appliance into the wall socket, make sure that the voltage(V) and fuse amperage
(A) specified on the rating plate of the oven correspond with the electrical power supply in your home.
If these specifications do partly or not at all correspond, immediately contact your local customer support
service or your dealer and do no plug in the appliance under any circumstances.

The appliance must not be built into a cupboard.
The oven must not be built in underneath a panel or a cupboard.

The following minimum clearances  between other objects / walls must be maintained for safety
purposes:
- Side l/r clearance       at least 5 cm
- Rear clearance          at least 10 cm
- Upper clearance        at least 20 cm

It must be stable  enough to easily support the appliance even if the oven contains goods.

You will thus prevent the appliance from tilting forward when the door is open.

Instruction for use

English

Instruction for use

4

9

The interior lamp may only be replaced by specially trained customer service personnel who is aware
of the related dangers.

The appliance works independently from the interior light. It can thus also be operated easily even if the

interior lamp has failed.

During operation clouds of steam escape through the air vents of the appliance and it may get very hot
within the  space of the above  mentioned minimum clearances.  The microwave oven should  thus be
installed so that no  objects sensitive to heat or moisture are located near the minimum clearances.
Avoid any possible overheating of the oven caused by unintentionally covering or sealing the air vents
When in operation the base of the oven may become very hot.  The worktop must thus be accordingly
heat-resistant.

The manufacturer works constantly at the further development of all products. Please therefore bear
this in mind as the form, set up and technology are subject to change, without prior notice.

Please note the general guarantee terms and the guarantee period stated in the attached guarantee
card. If the appliance documentation does not include a guarantee card, please contact your dealer.

f)

   

Place the undercarriage in the circular track on the oven interior floor.

g)

  

Lay the turntable onto the undercarriage. By gently turning it, the guide fits into the drive shaft.

Customer service jobs resulting from improper operation of the oven are liable for payment even during
the guarantee period.

Is the plug firmly inserted in the socket?
Is the power socket under current?

Is the fuse intact?
Was the timer set properly? (first turn beyond the required time and then back accordingly)
Does the oven door close tightly?
Is anything stuck in the door?

CAUTION!

4 Rating Plate

5 Plugging in your appliance

What is when.........

(test this by plugging in another kitchen appliance)

Under no  circumstances should  you subject the appliance  to any tests other  than those de-
scribed here or attempt to repair it yourself by technical means.

Warning !

10 Calling the Customer Support Service

Steam escaping from the air vent is quite normal during operation.  This is not a malfunction.

To ensure prompt help when needed, please have ready the following data before calling the customer
support service:

Appliance Type / Model (see rating plate)
Date of purchase
Name and location of your dealer
Description of the malfunction

The address and phone number of the customer support service center  responsible for your appliance 
can be found in the attached customer support service directory , or in the guarantee card.
Otherwise contact your dealer .

1

1 Guarantee

Summary of Contents for EA-2080M









Reviews: