End of programme
Six beeps will indicate that the wash cycle has finished and all the programme indicators light.
22
en
If the the door is closed, the delay indicator “
I
” will blink and decrease, the programme will start until
the delayed start indicator “
I
” goes out .
Press programme button
“ G ”
t
o choose the desired programme.
D
elayed start programming
Y
ou can delay the start of a programme in increments of 2 hours up to 12 hours.
Switch dishwasher
O
N
.
Immediately press the Delayed Start button “
J
”, the delayed start indicator lights, the start time for
the wash cycle can be delayed for 2,4,6,8,10 or 12 hours.
Press the Delayed Start button “
J
” as many times as necessary until the numerical display shows
the required delay.
To cancel the time delay setting, pressing the Delayed Start button until the delayed start indicator goes out.
F
G
0
1
A
J
I
C
S
witching the dishwasher OFF
S
everal minutes after the programme has ended:
Open the door.
Set ON-OFF button
“ A ”
to OFF.
Remove dishes, etc. when they have cooled down.
I
nterrupping the programme
A
cycle that is underway can be modified if it has only been running for a short time. Otherwise, the
detergent may have already been used, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled ( see the paragraph entitled, Loading the
detergent).
To concel a programme that is underway, press programme button “G” and hold it in for about 3
seconds.
Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open
the door fully until spray arm has stopped rotating.
When you open the door, the dishwasher will beep ten times every thirty seconds.
If the appliance has already heated up or the hot water was switched ON and then the appliance door
opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may
open due to expansion.
