Installation of Continuous Base Moulding
Position the washing machine in the cut-out in the kitchen cabinet:
1. Install the continuous base moulding , following the
manufacturer’s instructions .
2. Slowly open the door of the dishwasher to check to see if the
door strikes or rubs against the base moulding.
3. If so, rest the bottom edge of the panel on the base moulding
and mark the part to be cut. Leave at least 3 mm of the play
between the panel and the base moulding to allow for the door to
rotate freely (Fig.11).
4. Remove the base moulding and trim it as needed, protecting the
surface that has been cut with a paint or similar wood finish (Fig.11).
5. Install the base moulding again (Fig.12).
Positioning the Unit within the Cutout (Fig.14)
Push the dishwasher into the cutout opening and turn the feet to
make it level and to adjust for height so that the crosspiece (A) for
fastening it in place located on the top part of the machine (Fig.14)
comes into contact with the counter .Align the door panel mounted
on the dishwasher with the doors on the adjacent cabinet (2).
Important:
The dishwasher must absolutely be fastened to the counter top to
prevent the machine from tipping when the loaded dish racks are
pulled out.
Adjustment of Back Feet (Fig.10A)
Insert the appliance in the cutout and then adjust the height of the
machine using the screws located at the bottom front .Use a screw-
driver to turn the screws in a clockwise direction to raise the dish-
washer and in an anticlockwise direction lower it.
How to use water-proof plastic
Firstly take off the water-proof plastic from the sticker with the ap-
pliance (see I, Fig.13). Secondly stick it on the bottom of the kitchen
board (see II, Fig.13). All of this can avoid humidity in the kitchen
.
NOTICE:
If power screwdrivers are used to make the
adjustment, make the final adjustment manually with
a normal screwdriver.
A
B
2Kg
7Kg
Fig.10
Fig.11
Fig.12
Fig.13
Fig.14
10
en
