Haier Aficionado M111, User Manual

Page: 7 / 36

6
English English
screw holes
doorstopper (right side)
middle pivot pin
central hinge
Freezer Door:
1. Remove hinge cover screw.
2. Remove the top hinge cover.
3. Loosen the top hinge screws using a Phillips head screwdriver.
4. Adjust the door or put a spacer in between and then tighten the screws.
5. Replace the top hinge cover.
Door Alignment
Reversing the Door Swing
This product allows you to reverse the door opening from left to right and
back. You can select your preference of door opening by following the
procedure to make the change.
Dismantling:
1. Affix refrigerator and freezer door by sticking adhesive tape on both
sides to hold doors in place.
2. Dismantle the hinge cover on the upper part of freezer door with a
Phillips head screwdriver, then remove the three screws that hold the
hinge. Take out the hinge by pulling it vertically, and keep it in a safe
place.
3. Remove the adhesive tape on freezer door, lift and take off the door,
and carefully put it aside.
4. Dismantle two screws of the central hinge, lift it and take off the central
hinge, and keep them in a safe place.
5. Remove the adhesive tape on refrigerator door, lift and take off
refrigerator door, and carefully put it aside.
6. Remove the doorstoppers from the bottom of the refrigerator and
freezer doors.
7. Move door stopper from right side bottom of refrigerator and freezer
door to left side bottom of refrigerator and freezer door, and fasten
with a screw.