Dial out number 1 has two times associated with it, an On and Off time. The OmniLT will only call this number if the time and
days are between the Dial Out 1 On and Dial Out 1 Off times and dates.
Press # to change the On and Off times -
See Set Up Codes
.
DIAL
OUT
1
ON:
12:00
AM
MTWTFSS
#=CHNG
DIAL
OUT
1
OFF:
NEVER #=CHNG
For example, if your normal work hours are 8 to 5 Monday through Friday, then set Dial Out 1 On to 8:00 AM MTWTF and Dial
Out 1 OFF to 5:00 PM MTWTF. With these settings, the system will call Dial Out Number 1 only if the alarm is activated on
weekdays between the hours of 8:00 AM to 5:00 PM.
The default for Dial Out 1 On is 12:00 AM MTWTFSS, and the default for Dial Out 1 Off is Never, so that Dial Out Number 1 is
always active.
The Time that was entered before setting an On or Off time to Never is saved, and will be redisplayed when a day is set in place
of Never. Setting both the Dial Out 1 On and the Dial Out 1 OFF times to Never will make Dial Out Number 1 never active.
Dial Out Numbers 2-8
The default Dial Out On and Off times are the same as Dial Out Number 1.
Dial Order
The dial order is the order in which call all will be placed if an Alarm is activated.
You can have the system make up to 8 calls in the event of an alarm. You may chose from Dial Out Numbers 1 - 8. You can
have the system dial a number twice (or more) which is suggested if you don't have a direct dial number at work, so that your
company operator can find you, if you aren't at your desk, and have you alerted for the next call.
Up to eight numbers may be entered. Enter the Dial Out Order by pressing the keypad digits 1, 2, 3, 4, 5, 6, 7, or 8 for Dial Out
Numbers 1, 2, 3, 4, 5, 6, 7, or 8, respectively. When you have entered the dial order of your choice, press ' # '. Enter a single ' 0 '
if no dial out is desired. The default Dial Order is 1 2 3 4 5 6 7 8.
Set Up Arming
To configure different arming and disarming options, from the Setup menu, press the 5 (ARM) key.
Entry Delay
The Entry Delay is the time, in seconds, that you have to turn off the alarm after entering your home. The entry delay
only
applies to the entry/exit zone (i.e. your doors). If you (or someone else) come in through a window, there will be no entry delay
and the alarm will sound immediately.
When you come in through a door on an entry/exit zone, the other zones are delayed too. This allows you to get to your phone or
console to turn off the security system, even if you have to go through a room protected by a motion detector.
Some doors (a back door or garage door) may be configured as a double or quadruple entry delay. If so, that door has two times
or four times the entry delay shown on the display.
The default entry delay is 15 seconds. If you wish to allow yourself more time to get in and turn off the security system, you may
set the entry delay between 15 and 45 seconds.
ENTRY DELAY: 15
15-45 SECONDS
↓
The console will beep and the new entry delay will be displayed.
61
Summary of Contents for SECURITY SYSTEM
Page 1: ...Owner s Manual Document Number 21R00 1 Rev 2 11 January 2006...
Page 81: ......
