1
1
5
5
REMOTE DAY/NIGHT SETBACK SWITCHES
The thermostat can be connected to a remote system or remote switch. A signal can be sent from the remote
location to change the thermostat temperature settings from the "DAY" setting to the "NIGHT" setting. To use
this mode, setup item 01 - "Communications mode" must be set to 24.
Run a two-conductor wire from the remote system or remote switch to the thermostat location. Make the
connections using supplied wire splices - See Figure 10.
* Red and yellow wires are not used.
Insulate each using a small piece of tape.
Figure 10 - Hookup to remote Day/Night setback switch
OTHER SYSTEMS
For connections to personal computers, utility management systems, and other automation systems, refer to
connection diagrams provided with personal computer software package or other system.