2
INSTALLATION
Hold the template (Installation Template – 32A10-1) against the wall so the top edge is at the
appropriate height and parallel to the floor. Using a Punch, or similar instrument, punch
through the center of each tick mark (+) on the template.
Drill a 1/4" hole at each punch mark. Using a pencil, draw a line around the quadrant of each
hole as shown as shown. Carefully cut along the pencil line.
4"
5 3/8"
DO NOT OVERSIZE THIS CUTOUT!
Remove the faceplate from the touchscreen by grasping the top and bottom edges of the
faceplate and carefully lifting the bottom edge away from touchscreen housing.
Run the power/communications cable (as determined by Table 1) from the controller location to
touchscreen location. Attach the wires to the supplied COMM cable assembly using the
supplied wire spice connectors.
Insert the COMM cable assembly through the rectangular cutout in the touchscreen backbox
and plug into the mating connector (J6) on the touchscreen.
Summary of Contents for OmniTouch 32A00-1
Page 12: ......