HAGOR Products GmbH | Oberbecksener Straße 97 | D-32547 Bad Oeynhausen | Telefon: +49(0)57 31-7 55 07-0 | Mail: [email protected]
Set length of stroke
Please note that the minimum and maximum lifting height is preset and there may be severe
damage to the lift, mounting frame, beamer etc.
•
Connect the beamer lift to the mains connection
•
Set the desired end positions of the lifting height
on the adjusting screws directly on the motor
•
The lift is factory set so that it retracts to the maximum. A space of
5 cm remains between the base plate and the ceiling.
•
The end stop is now set so that there is also space for beamers with a
greater height. Adjust the upper end stop so that the beamer has enough
space between the base plate and the ceiling.
•
Now set the desired maximum exit height.
•
Adjust the length of the cable drag chain to the lifting height.
Make sure that the kink area does not run beyond the device storage space. If
necessary lay them in the offset (2 kink areas). It is also possible to move the
upper fastening point of the cable routing (direct ceiling fastening) in order to move
the kink area of the cable duct over the installation area.
•
Move the lift to the top position and check the minimum installation height when
retracted. Compare this with the height of the beamer to be installed to rule out
that it can be pinched when driving in.
•
Also observe the assembly instructions of the projector manufacturer regarding
installation dimensions in closed housings to ensure operation and ventilation.
•
Test the space in a trial operation before installing the beamer on the base
plate and check for quiet and smooth operation. Make sure that the lift runs freely.
•
If necessary, use a pedestal or a ladder to ensure that the lower plate is easily
accessible to you. A platform is preferable to a ladder. Make sure that the platform
or the ladder is secure!
A = final position CLOSE
(
+
) closer
(
-
)
less close
B = final position OPEN
(
+
) open
(
-
)
less open