Depress
the to
enter the appropriate
VALVE CAL
calibration
number.
VALVE
CAL
6
Depress
to select.
Enter the new calibration using the number keys
1-0
.*
Depress
when finished.
This number indicative to the type of valve installed
on the sprayer and its functions. This number may be
refined within the PWM valve ranges. Refer to the Ra-
ven manual for more information on this number.
Enter
Enter
*The
VALVE CAL
number is preprogrammed as 0043, but can be adjusted to suit your needs. Refer to the Raven manual for instructions.
90
THIS IS JUST A GETTING STARTED GUIDE!
REFER TO THE RAVEN INSTALLATION
AND OPERATION MANUAL FOR MORE INFORMATION AND TROUBLE SHOOTING.
Performing a SELF TEST
Depress
to
perform a
SELF TEST.
SELF
TEST
8
Depress
to select.
Enter the speed that you wish to simulate using the
keys
1-0
. Verify the speed in the lower corner of the dis-
play. The self test speed will clear itself when motion of
the vehicle is detected. A speed cal value of 900 or
greater is recommended when operating in this mode.
To verify accuracy, you will need to verify the flow
meter. To do so, collect one nozzle’s spray for one min-
ute and multiply it by the number of nozzles on the
booms. This should equal the amount measured
through the flow meter.
To get the amount of fluid measured through the flow
meter depress
This will be your flow rate.
Enter
TOTAL
VOLUME
Changing VALVE CAL
A. RAVEN CONSOLE (SPRAYER)
V.
SYSTEM PROGRAMMING
SYSTEM PROGRAMMING
