ONE WATTER – Tube Pedal Amplifier
4
Operation
As with all tube amplifiers, ONE WATTER takes approximately 30 seconds to warm up
and start working. The left footswitch turns unit on and off. Output jack connects
straight to any speaker cabinet.
For a line-level signal (recording or PA), use the right channel from a stereo plug on
output jack (left channel is speaker).
For maximally warm tones, run boost channel GAIN at about 10 o’clock and VOLUME
about 2 o’clock.
If you experience hum or buzz, use the supplied grounding wire to connect to an Earth
ground somewhere (center screw on outlet).
Warnings
Do not operate pedal without tubes installed!
Power tube gets hot!
Do not spill liquids onto pedal.
Do not use a standard negative 9V pedal power supply, this unit uses positive 15V at
high current (1150mA).
Be careful not to break glass of tube when installing or removing.