*
to
or
70
3. Programming
1.
Change the control panel to installation
mode if necessary by pressing the
following sequence on the control panel
keypad or the hardwired control interface
remote keypad:
then:
2.
Programme the detector as follows:
CAUTION: during recognition programming,
the product to be programmed for use with
the control panel does not need
to be placed next to it. In fact, we recommend
you place the product at a short distance from
the control panel (at least 2 m away).
CAUTION: the detector number is automatically allocated by the control panel during
programming.
CAUTION: the control panel indicates there is an error by emitting 3 short beeps.
When this happens programming should be carried out again.
master code
engineer
installer code
* Depends on the type of the control panel
10 s max.
Press and hold the
“test”
button until
the control panel
responds
The control panel
waits for a
group
to be chosen (from
1 to 4
)*. Choose
the groups by
pressing the
corresponding
numeral on the
control panel keypad
The control panel
waits for the time
delay to be chosen.
0: immediate
1: delayed
The time delay is
chosen by pressing
“0” or “1” on the
control panel keypad
The control
panel gives a
voice message
to confirm
Press
*
then
#
on the control
panel keypad
)
)
)
)
)
then
“detector X”
“group?”
“time delay?”
“beep, detector X,
group Y immediate
(or delayed)”
