hager coviva Smartbox TKP100A, Quick Start Manual, Page: 131 / 132

TKP100 Controller reset modes
For detailled description of use & effect of each reset modes please refer to "TKP100 Reset Modes"
page 22.
Network reset
1. Press the RESET
button for more than
5 seconds
2. When the unit
flashes in blue,
release RESET
button shortly, then
press it again to
confirm.
3. When successful,
a short series of fast
blue flashes of the
signalling RGB confirm
the reset.
Flashing
Users reset
1. Press the RESET
button for more than
20 seconds
2. The units flashes
in blue, then when it
starts flashing in yel-
low, release RESET
button shortly, then
press it again
to
confirm.
3. When successful,
a short series of
fast
yellow flashes of the
signalling RGB confirm
the reset.
Flashing
Factory reset
1. Simultaneously
press RESET
and power on
the TKP100
2. Maintaining
the RESET button
pressed while the
unit starts flashing
slowly (approximately
5 seconds).
3. When the unit flashes
faster in red, release
the RESET button.
Wait for a few minutes
until the unit completely
stops flashing
, which
indicates the end of the
sequence.
Flashing