Sliding Door Hardware – 9850 – Pocket Frame
Installation Instructions
I-SD00333
Rev 2, Rev Date: 11/20/17
Page 4 of 6
Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325-9995 www.hagerco.com
4
Install Split Studs
Engage ends of split studs onto floor plates so that the slots on the backside are against the header. If the split
studs must be shortened for shorter doors, determine which end of the stud has the slots close to the end and
cut off the opposite end.
Note: for best results, pre drill holes before screwing
Butt one pair of split studs against the header nailing boards and screw to header. Screw the other pair of split
studs to the header midway between the first pair of split studs and the rough stud on the pocket side. Re-
position the floor plates between the chalk lines. Plumb the split studs to make sure they are vertical and square.
Screw the floor plates to the floor.
5
Mount Door Hardware
Mount Pocket door plate 1” from near edge to Pocket door edge, mount Opening plate 2-3/4” from near edge to
Opening door edge, secure bumper as close to dead center on pocket edge of door or back pocket jam.
Note: when installing bi-parting doors change opening distance to 3-3/4” from edge of door.
end
Opening end
