Sliding Door Hardware – 9850 – Pocket Frame
Installation Instructions
I-SD00333
Rev 2, Rev Date: 11/20/17
Page 2 of 6
Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325-9995 www.hagerco.com
Prepare the header and track assembly, note that the track in this kit will fit a 4’-0” (121.92 cm) door without
modification, but it can easily be cut to accommodate any size door less than 4’-0” (121.92), as shown below
using the dimensions from Table 2.
Determine the height of the finished floor. Then mark
each side of the rough opening the determined
distance using the bracket nail height dimension from
Table 1. For example, mark points 98-1/4”” (249.5 cm)
above the finished floor when using a door 8’-0” in
height.
Note: if measuring from a rough sub-floor, be sure to
add the estimated thickness of the finished floor
material and/or carpeting
Next, drive a flat- headed nail on the centerline of
each framing stud at the appropriate height mark,
until only 1/8” (3.17 mm) of the nail is left protruding.
The slot in the end brackets will slide over these nails.
Opening Dimensions From Door Widths (Table 2)
Header Length
Nailing strip length
Rough Opening Width
D
oor Widt
h
(W)
4’-0”
96-7/8”
49”
97”
3’-6”
84-7/8”
43”
85”
3’-0”
72-7/8”
36”
73”
2’-6”
60-7/8”
31”
61”
2’-0”
48-7/8”
25”
49”
Custom
(2 x W) + 7/8”
W + 1”
(2 x W) + 1”
(A) Cut nailing strips only, using the
dimensions from Table 2 as your
guidelines.
(B) Cut the pocket end of the header
board to the appropriate length using
the header length in Table 2 as your
guidelines.
(C) Turn the track assembly back over and
cut the track 1-1/2” (38.1 mm) back from
the end of wood header.
2
Mount Brackets
