END CAP
SLIDE INSERT
HOLD OPEN STOP
MOUNTING
SCREW
Hold Open Stop
Stop Only
Slide Insert
5 3/16"
131.8
19 7/8"
504.8
4 13/32"
112
9 1/16"
230
3/4"
19
1"
25.1
1"
25.8
SLIDE TRACK
SLIDE ARM
SLIDE ARM INSERT
SCREW
END CAP
PARTS
INSTALL TRACK ARM - PULL SIDE APPLICATION (RIGHT HAND SHOWN) 120 TEMPLATE
WITH SLIDE ARM
WITHOUT SLIDE ARM
NOTE: IF USER
WISHES
TO HAVE A
LESSER
SWING ANGLE,
SIMPLY
MOVE HOLD
OPEN STOP
OR STOP ONLY
AWAY FROM
THE PIVOT
HINGE IN
INCREMENTS
OF 1/2" UNTIL
DESIRED
ANGLE IS
ACHIEVED.
Installation Sequence:
Use template to locate holes on door and frame. Drill 1/8" pilot holes for the self tapping screws.
1.
Determine door width, adjust spring power of closer by referencing closer installation instructions.
2.
Fasten closer body to door with power adjustment nut away from hinge.
3.
Fasten slide track to frame face with open side facing down and with hold open stop end toward
4.
hinge edge of door.
Place slide arm on pinion shaft of closer at preload of 45 degree angle out from door face.
5.
Secure arm with arm washer and arm screw.
6.
Secure other end of slide arm to track by screwing it to the slide insert. Open door to required
7.
opening angle. Then slide stop only/hold open stop up against slider insert and tighten down the
stop only/hold open stop via set screw.
CENTERLINE
OF HINGE
5300 Series Track Arm
Installation Instructions
I-CL00579
REV: 1 REV DATE: 1/11/2014
Page 1 of 3
