4200 Rim Exit Device
Installation Instructions
I-ED01625
Rev -, Rev Date: 07/23/13
Page
4
of
4
3)
Install end cap mounting bracket with provided Sex Bolts and Through Bolts or Mounting Screws.
a.
Slide mounting bracket into push bar channel.
b.
Level the device.
c.
Mark mounting holes, and prepare the holes by drilling the appropriate sized holes based on mounting hardware
used.
d.
Install mounting bracket with hardware that was prepped for.
4)
Install the strike in the location previously prepared with mounting screws.
-
Check that the device operates smoothly and that the latch bolt engages securely. Adjust strike if required.
-
After the device works properly, drill the center hole and install the mounting screw.
5)
Apply Covers
a.
Attach Head Assembly, End Cap, and Latch Covers with provided M4x8 screws.
Channel
Mark the two holes
Head Cover
M4x8 Screw
M5x12 Screw
Strike
Frame
