4200 SVR Exit Device
Installation Instructions
I-ED01626
Rev 1, Rev Date: 07/29/14
Page
5
of
6
4)
Install the top and bottom strike in the locations previously prepared with mounting screws.
-
Install the top strike with just the outer screws at first.
Top Strike Bottom Strike
5)
Install top and bottom latches in the locations previously prepared with mounting screws.
Top Latch Bottom Latch
6)
Install Bottom Rod
-
Screw the bottom latch bolt fully into the bottom rod with a jamb nut and lock washer on the strike.
-
Insert the bottom latch bolt into the bottom latch housing.
-
Press in the push bar to raise the slide bar in the housing and slide the rod over the slide bar.
-
Align the hole in the bottom rod with the hole in the slide bar and insert and tighten the cotter key.
-
Adjust the latch bolt so that when the push bar is pressed that there is a gap of 2mm between the bottom of the
latch bolt and the top of the strike as shown in template T-ED01672.
Bottom Rod
Lock Washer
Jamb Nut
Latch Housing
Latch Bolt
2~5mm
